Every professional aviator has his own ideas as to the design of the propeller, one of the most important features of flying-machine construction. While in many instances the propeller, at a casual glance, may appear to be identical, close inspection will develop the fact that in nearly every case some individual idea of the designer has been incorporated. Thus, two propellers of the two-bladed variety, while of the same general size as to length and width of blade, will vary greatly as to pitch and "twist" or curvature.
What the Designers Seek.
Every designer is seeking for the same result--the securing of the greatest possible thrust, or air displacement, with the least possible energy.
The angles of any screw propeller blade having a uniform or true pitch change gradually for every increased diameter. In order to give a reasonably clear explanation, it will be well to review in a primary way some of the definitions or terms used in connection with and applied to screw propellers.
Terms in General Use.
Pitch.--The term "pitch," as applied to a screw propeller, is the theoretical distance through which it would travel without slip in one revolution, and as applied to a propeller blade it is the angle at which the blades are set so as to enable them to travel in a spiral path through a fixed distance theoretically without slip in one revolution.
Pitch speed.--The term "pitch speed" of a screw propeller is the speed in feet multiplied by the number of revolutions it is caused to make in one minute of time.
If a screw propeller is revolved 600 times per minute, and if its pitch is 7 ft., then the pitch speed of such a propeller would be 7x600 revolutions, or 4200 ft. per minute.
Uniform pitch.--A true pitch screw propeller is one having its blades formed in such a manner as to enable all of its useful portions, from the portion nearest the hub to its outer portion, to travel at a uniform pitch speed. Or, in other words, the pitch is uniform when the projected area of the blade is parallel along its full length and at the same time representing a true sector of a circle.
All screw propellers having a pitch equal to their diameters have the same angle for their blades at their largest diameter.
When Pitch Is Not Uniform.
A screw propeller not having a uniform pitch, but having the same angle for all portions of its blades, or some arbitrary angle not a true pitch, is distinguished from one having a true pitch in the variation of the pitch speeds that the various portions of its blades are forced to travel through while traveling at its maximum pitch speed.
On this subject Mr. R. W. Jamieson says in Aeronautics:
"Take for example an 8-foot screw propeller having an 8-foot pitch at its largest diameter. If the angle is the same throughout its entire blade length, then all the porions of its blades approaching the hub from its outer portion would have a gradually decreasing pitch. The 2-foot portion would have a 2-foot pitch; the 3-foot portion a 3-foot pitch, and so on to the 8-foot portion which would have an 8-foot pitch. When this form of propeller is caused to revolve, say 500 r.p.m., the 8-foot portion would have a calculated pitch speed of 8 feet by 500 revolutions, or 4,000 feet per min.; while the 2-foot portion would have a calculated pitch speed of 500 revolutions by 2 feet, or 1,000 feet per minute.
Effect of Non-Uniformity.
"Now, as all of the portions of this type of screw propeller must travel at some pitch speed, which must have for its maximum a pitch speed in feet below the calculated pitch speed of the largest diameter, it follows that some portions of its blades would perform useful work while the action of the other portions would be negative --resisting the forward motion of the portions having a greater pitch speed. The portions having a pitch speed below that at which the screw is traveling cease to perform useful work after their pitch speed has been exceeded by the portions having a larger diameter and a greater pitch speed.
